JINYU · Buyer question
Are all commercial wok burners basically the same?
No. Commercial wok stations differ in cooking system, cookware fit and the work each position can do. Gas wok burners and concave induction zones are different equipment categories. Even within one category, similar exterior dimensions do not establish the same control response or cooking result. Start the comparison with a specific dish, its batch weight and the wok the chef intends to use.
For a gas proposal, request the burner configuration, gas type and supply requirements for that exact unit. Ask how the burner supports the intended wok and how its controls handle the change from heating an empty vessel to cooking a full batch. For an induction proposal, request the compatible cookware material, supported vessel dimensions and cooking-surface shape. The models linked below are induction units. Their electrical ratings do not describe a gas flame or establish an equivalent gas burner output.
JY-TSPA5+5 has one flat zone and one concave wok zone, each rated at 5 kW. Its 10 kW total covers both positions; it is not a 10 kW rating for the wok position. The listed supply is 220 V and the body measures 850 x 500 x 200 mm. Include your wok diameter, base curvature and handle position in the fit request. The record does not give a supported wok diameter or batch capacity, so neither can be inferred from the body dimensions.
JY-TSPT-5D shows why an equal power figure does not make two positions interchangeable. It is a 5 kW, 220 V soup cooker with a single flat surface for magnetic flat-bottom cookware. The body measures 400 x 500 x 200 mm, and cookware is not included. Its 5 kW rating matches the rating of one zone on JY-TSPA5+5, but its flat surface does not establish suitability for the same round-bottom wok. Use it as a separate pot-station reference when the menu also includes soup or simmering.
Compare candidates with the same recipe, ingredient starting temperature, batch weight and intended vessel. Record preheat time, cooking time, the result after adding ingredients and the interval before the next batch. Include a lower-heat task if the station must also hold a sauce or simmer between orders. Ask for the control settings and vessel dimensions used in the demonstration so the comparison describes an actual task. These are proposed trial measurements, not published performance results for either linked model.
Put the selected configuration on a counter drawing with cookware handles and the operator position. Send the dish, batch weight, vessel dimensions, available utilities and model links through the inquiry entry. Request a reply that identifies the offered cooking system, power per position, cookware fit and installation drawing. That brief gives the buyer a basis for comparing proposals without treating a shared product name or a larger total power figure as proof of cooking capacity.
Prepare this information
- Gas or induction system and exact configuration offered
- Wok material, diameter, curvature and handle position
- Power per cooking position, total rating and available utilities
- Dish, batch weight and ingredient starting temperature for a comparison trial
- Control settings, cooking result and interval between batches
- Counter drawing and installation information for the selected model
Compare flat and concave induction cooking positions