JINYU · Buyer question
Do I need a special electrical connection for my unit?
The connection you need depends on the unit you order and the supply at its intended location. Start with the electrical specification for that configuration, then have your site electrician compare it with the available supply and connection point. The linked GN-660RT and GN-900RT pages describe 220-240V/50Hz cabinets. Those pages do not specify a plug type or circuit arrangement, so they do not establish whether your existing outlet is suitable.
The published rated power is 250 W for GN-660RT and 350 W for GN-900RT. Both linked configurations use 220-240V/50Hz. Include these ratings beside the model codes in your equipment schedule. Rated power alone does not give you the unit's complete connection requirements. Request the rated current, phase, connection method and any circuit requirements in the documentation for the unit offered, rather than choosing a plug or circuit from the wattage figure.
Ask for the electrical specification, installation instructions and a rating-label image for the quoted configuration. Request details of any supplied cable and plug, including the cable length and exit position. If you need a different voltage or frequency, state the required supply in the inquiry and ask which configuration can be offered. Keep the document reference for the offered configuration with the quotation. Information for a different version of the same model does not describe the unit you are ordering.
Show the cabinet and proposed connection point on your counter drawing. For these rear-access displays, include the staff side, the rear sliding doors and nearby equipment. Measure the connection point's position relative to the cabinet and add photographs of the intended location. Details of the supplied cable let the site team assess its reach and proposed route on the drawing. Ask your electrician to review both the location and the electrical requirements for that arrangement.
If you are ordering several displays, list each model, configuration, quantity and position on a separate schedule line. A GN-660RT at one counter and a GN-900RT at another may have different site conditions even though both published records list 220-240V/50Hz. Include the other equipment planned at each location in the information you give the electrician. Record connection questions against the relevant schedule line so the equipment contact can answer for the correct cabinet.
Use the inquiry form below to send the model codes, quantities, destination and site supply details you have. Describe any missing documents and ask how to share the marked drawing and photographs. Keep the agreed electrical specification with the order and pass the same version to your receiving and installation teams. At delivery, compare the unit's model and rating label with those records. Report any difference with the order reference and label photograph so the equipment contact can identify the supplied configuration.
Prepare this information
- Model code, quantity and location for every equipment schedule line
- Voltage and frequency requested for the offered configuration
- Published rated power of 250 W for GN-660RT or 350 W for GN-900RT, as applicable
- Electrical specification, installation instructions and rating-label image for the offered unit
- Documented rated current, phase, connection method and circuit requirements
- Supplied cable length, cable exit position and plug details
- Counter drawing with cabinet and measured connection-point positions
- Rear-door access, nearby equipment and photographs of the intended location
- Site supply details and connection questions for the site electrician
- Agreed document version for comparison with the delivered model and rating label
Compare RT countertop cake display models