JINYU · Buyer question
How do I dimension tote handle attachment positions from a shared baseline?
Draw the tote face with the finished opening edge and side boundaries labelled. Choose a horizontal reference for the handle pair, such as the panel centerline, and show where it sits between the named boundaries. Dimension each attachment from that reference. State whether the dimension ends at the strap edge, strap centerline or stitching; these are different locations.
Locate the handle ends vertically from a named opening edge or hem seam. Mark the extent of each end separately from the visible handle rise. Put strap width and the distance between the attachment references in their own dimension entries. If the top edge is curved, identify the baseline used instead of placing a dimension arrow against an unspecified point on the curve.
Ask the returned drawing to retain the same references. Compare each end position before comparing the distance between the pair, because a pair can keep its spacing while moving across the panel. Send the annotated view through the inquiry entry with the tote reference and identify which dimensions describe the requested arrangement.
Prepare this information
- Position dimensions end at named features
- Vertical baseline identified
- Each handle end located independently