JINYU · Buyer question
How do I record a beverage cooler lighting-control demonstration?
Begin the demonstration with the cabinet reference, offer revision and operating document visible in the record. Ask the demonstrator to point out the lighting control before using it according to that document. Record the initial state, the action performed and the resulting illuminated areas. Keep the sequence continuous where possible so a still photograph of the result can be traced back to the control action that produced it.
Use the same camera position for the before and after views. Record the room lights, door positions and sample arrangement, because changing these at the same time makes the images harder to compare. Where the camera allows it, retain the same exposure settings and note those settings with the images. If the recording changes exposure automatically, describe that limitation beside the comparison. The images document visible coverage and operation in that scene; they do not provide a measured brightness value, colour specification or energy figure.
Include a wide view showing the whole cabinet and a closer view of the control labels. If a lighting section appears different from the proposal, identify its location on the drawing and retain the corresponding recording timestamp. Send those references in the GN-868FM inquiry with a precise question about the observed difference. Repeat the affected sequence after receiving a revised explanation or configuration. Keep the original recording as well as the repeat, naming the cabinet and document version in both. This gives the shop a demonstration record it can compare with the equipment received.
Prepare this information
- Initial state and control action recorded together
- Camera view and room conditions retained
- Observed difference linked to a drawing and timestamp
Review the two-door beverage cooler series