Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

How do I record bag measurement tolerances in an order specification?

Record each bag dimension on a drawing with named endpoints and a unit. Separate body width, body height, base depth, opening width and handle drop into individual entries. State whether the bag is flat, opened or packed when measured. For handle drop, show the line across the opening and the point on the handle used for the measurement. This gives another inspector a repeatable setup.

Put the target value and the agreed upper and lower limits beside each dimension. Write limits explicitly rather than leaving a general tolerance note to cover every feature. Ask for the same measurement method on the returned specification. If a gusset or curved panel makes an endpoint unclear, add a close drawing or photograph identifying the precise edge being used.

Measure the sample with that setup and enter the observed values in a separate column. Keep photographs of the ruler position and record any disagreement about the method before changing the target. Submit the marked drawing through the inquiry entry. No numerical tolerance is implied by a catalogue dimension; the project record needs its own agreed limits and measurement conditions.

Prepare this information

  • Named endpoints and measurement condition
  • Target and explicit dimensional limits
  • Observed values and ruler photographs

View the canvas tote bag project

Matching bag projects

Discuss your bag specification

Send your bag brief