JINYU · Buyer question
How do I record misalignment between the two halves of a tote snap fastener?
Empty the sample and place it in the orientation shown on its closure drawing. Label the two bag faces A and B and photograph the open mouth from above. Show each snap half and its attachment area. Record the sample identifier and drawing revision beside the images. If there is more than one snap pair, number the pairs on the same photograph rather than describing them all as the middle closure.
Bring the mouth together as the user would, keeping the handles in their usual position. Observe where the two halves meet before stretching, twisting or folding a panel to align them. Take a side view if an overhead view hides the offset. Describe the movement needed to engage the pair: shifting one face sideways, raising one edge or moving a fold out of the way. If measuring an offset, name the reference points and state whether the bag is lying flat or held upright. These setups can produce different panel positions.
Compare the attachment locations with the labelled drawing and mark the observed mismatch on the corresponding faces. Send that record through the canvas tote inquiry with both the starting view and the view after alignment. Ask which location or construction detail should be reviewed. Keep any proposed relocation on a separate drawing revision; moving an attachment on the original sample would remove the reference needed to compare the result. Repeat the same empty-bag arrangement when the revised sample arrives.
Prepare this information
- Both snap halves and bag faces identified
- Starting offset separated from manual alignment
- Requested relocation marked on a new drawing revision