JINYU · Buyer question
How do I review proposed cooler graphics around door handles and frame edges?
Use a full door view to locate the proposed graphic, then add a close view of the handle and surrounding frame. Mark the artwork boundary on both images with the same label. Identify whether the proposal is for a glass area, a frame face or a separate panel. Those surfaces have different outlines; a rectangle copied from a front photograph does not describe how the graphic meets a handle base or a change of surface.
Show where a hand approaches the handle in the intended use position. A paper overlay held in front of the cabinet can help discuss whether lettering falls behind the grip or becomes obscured by a hand. Label it as an arrangement mockup, with its date and cabinet reference. Keep the handle visible in the photograph. If an edge is hidden by the overlay, add an unmarked detail view rather than inferring the covered geometry.
Ask for the proposed application boundary on the actual offered door drawing. Any trim, gap or cutout should be shown there with its own reference; do not take a value from another cabinet and apply it to GN-868FM. Send the full view, detail view and marked question through the inquiry entry. When a revised drawing arrives, compare the handle position and artwork boundary together. Changing only the lettering position can leave the original question about the handle area unanswered.
Prepare this information
- Full door and handle detail share a location label
- Glass frame and panel areas distinguished
- Proposed cutouts tied to the offered door drawing
Review the two-door beverage cooler series