Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

How should I mark an assembly opening in a tote lining drawing?

On the lining panel map, identify the seam containing the proposed assembly opening. Mark its endpoints from named seam junctions or panel edges. Give the opening its own callout so the reader can distinguish it from a pocket mouth, an intentionally open lining edge or a gap caused by an incomplete sketch.

Use an enlarged detail to show the proposed finished condition after assembly. Label the edge arrangement and closure stitching, and state which face is visible from inside the bag. If the construction proposal uses a different assembly route, ask for that route and its finished closure to be drawn rather than retaining an opening that no longer belongs in the design.

Keep assembly and finished views labelled separately in the inquiry attachment. Compare the returned detail against the panel map: the opening location and closure reference should agree. A sample photograph used later should identify the same seam and drawing revision so the finished closure can be located for inspection.

Prepare this information

  • Opening endpoints located on a named seam
  • Finished closure has its own detail
  • Assembly and finished views labelled

View the canvas tote project

Matching bag projects

Discuss your bag specification

Send your bag brief