Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

Is there a tolerance in bag dimensions?

Yes, a bag specification can include a permitted dimensional variation. There is no numerical tolerance in the linked JY-NWB-LH01 or JY-NWB-GS01 model records, so request the limits for the version you are discussing. Write the intended size beside its allowed variation. A target dimension describes the requested size; the tolerance defines the acceptable departure from it. Keep the proposed limits separate from the measurements actually obtained.

Start with a drawing that shows the ends of each measurement. Mark body width, body height and the opening edge. State whether width is measured across the outside or between seams, and keep usable internal space separate from external size. Handle drop needs its own reference points. Two readings are comparable only when they refer to the same dimension, so send the marked drawing with your size request.

For a gusseted bag, show what the depth figure means. A folded gusset panel and the depth of the opened base are different measurement references. JY-NWB-GS01 has a gusseted non-woven shopping bag body. Its page asks for the full packed-item footprint and height, including the widest part. Put those contents dimensions beside the proposed bag dimensions to explain where clearance matters.

Use one measurement method for the reference sample and subsequent comparisons. Record the units and whether the bag is empty and flat or opened around its contents. Lay the tape along the marked dimension without pulling the fabric to reach the target. Photograph the tape endpoints with the sample identifier visible. When readings differ, first compare the bag position, endpoints and units. Keep any agreed preparation conditions with the method.

Check packing fit as well as dimensional readings. Insert the intended contents, remove them and inspect the available space at the opening and base. Include retail wrapping in that trial. JY-NWB-LH01 has a non-woven body with attached loop handles; its guidance asks for contents height and handover clearance. Record whether you can grip the handles above the packed contents. An external width alone does not answer that fit question.

Send the drawing, model reference, quantities and packing photographs through the inquiry entry below. Ask for the offered dimensional limits and the method used to assess them. Save the agreed specification and sample identity together, then record each observed dimension against its target and limits. If a proposed size or limit changes during discussion, label the revision so later sample and order checks use the same agreement.

Prepare this information

  • Model reference, requested quantities and fully wrapped contents dimensions
  • Target size and offered permitted variation for each dimension
  • Drawing with measurement endpoints and internal or external size labels
  • Gusset definition, units, bag position and agreed measurement method
  • Identified sample photographs, packing fit and handle clearance observations
  • Agreed drawing revision, dimensional limits and recorded sample readings

Compare bag styles for your size and packing brief

Matching bag projects

Discuss your bag specification

Send your bag brief