JINYU · Buyer question
What clearances need to be taken into account when these cookers are installed?
Plan the gaps at the rear and sides, overhead space, air paths and access around the cooking station. Get the numerical installation clearances from the instructions for the exact cooker configuration offered. The linked model records give body sizes, but they do not state minimum distances to walls or other equipment. On your layout, label each proposed gap and the surface beside it. Send the drawing and model reference so the reply can address your counter arrangement.
Begin with the appliance outline. JY-TSPT-5D has a 400 x 500 x 200 mm body and one flat cooking surface. JY-TSPA5+5 measures 850 x 500 x 200 mm and has one flat zone beside one concave wok zone. These measurements are width, depth and height. They describe the bodies, not the counter space needed for a complete station. Draw the rear splashback, counter edge and any side joinery around each outline.
Add the surrounding equipment and overhead fittings to the drawing. A neighbouring fryer, oven or hot counter belongs on the plan, along with the materials of nearby panels and walls. Request an installation drawing that identifies the offered cooker's air openings and required free space. Compare that drawing with shelves, counter fascias and any proposed enclosure. Record where a panel might cross an air path and ask about that specific position. Check the model's installation instructions for underside ventilation and suitability for an enclosure.
Check the movement of the actual cookware separately. For JY-TSPT-5D, the recorded cookware requirement is magnetic flat-bottom cookware, which is not included. Mark the intended pot diameter, handle positions and lid-lifting space. For JY-TSPA5+5, show the pan on the flat zone and the wok on the concave zone together. Rehearse lifting and transferring empty cookware on a marked counter layout. Look for handles crossing the neighbouring station, a lid meeting a shelf or an operator reaching across another pan. Include the extraction arrangement above this working area in the layout review.
Leave cleaning, connections and maintenance visible on the same plan. Show how staff reach the counter around the appliance, where the connection is proposed and which panels or adjacent units limit access. Request the model-specific connection and service-access information rather than assuming the unit can be serviced from the front. Give each drawing a date or revision so the installer and counter fabricator discuss the same arrangement. Use the inquiry entry below to send the selected model links, measured layout, photographs and cookware sizes. Ask for a reply that marks the required installation gaps separately from the space reserved for staff and cookware.
Prepare this information
- Selected model and body outline on a measured counter drawing
- Rear, side and overhead gaps with nearby surface materials
- Air-opening locations and clearances from the offered model instructions
- Adjacent hot equipment, shelves, panels and extraction arrangement
- Cookware sizes, handle positions, lid lifting and operator movement
- Cleaning, connection and service access on the same drawing revision
Compare the commercial induction cooking models