Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

What should I show if a clip catches on a backpack internal mesh pocket?

Photograph the object with the clip fitted as it will be carried. Show the clip tip, its opening and the part projecting beyond the object. Identify the sample pocket and mark whether the object belongs inside that pocket or passes beside it during main-compartment access. These are different contact paths, so draw the intended movement before repeating the action.

Move the object along that path and record the point where the clip touches the mesh. If it catches, photograph the contact before releasing the clip by hand. Show whether the tip entered a mesh opening, met the pocket border or caught a closure component. Keep the original direction of movement visible in the wider view. After release, photograph the same area of mesh and the clip tip. Record any visible change at that location without pulling harder to create a different event.

Attach the contact views to the project inquiry, naming the object and the affected pocket area. A proposed response may change the mesh, the border or the route past the pocket; mark the specific revision on the drawing. Repeat the original movement on the revised sample with the same clip orientation. Retain the before-and-after contact photographs so the review follows the observed snag rather than a general description of the pocket material.

Prepare this information

  • Clip geometry and intended path photographed
  • Contact located before manual release
  • Affected mesh area shown after release

View the backpack and travel bag project

Matching bag projects

Discuss your bag specification

Send your bag brief