Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

Which measurement reference should I use for a beverage cooler door seal drawing?

Ask the parts supplier to mark the required measurement points on a drawing before preparing the dimension sheet. A width measured at the outside of the seal and a width measured at its attachment line describe different spans. Write the reference beside every number, including whether the measurement was taken with the seal fitted and the door open or closed.

Photograph the measuring tool and both endpoints for each span that can be reached with the seal in place. Keep width and height on the same labelled sketch and record the units once in its heading. If a corner is distorted or missing, mark that area as damaged instead of estimating the original corner location. Ask which additional drawing or identification is needed to resolve that dimension.

Attach the GN-868FM equipment label, door map and dimension sheet to the inquiry. Request a proposed replacement drawing using the same reference points. Compare like spans in a table: requested reference, observed measurement and proposed dimension. Leave an unresolved reference explicitly identified as a question. A close numerical match has little meaning when the two measurements start at different features.

Prepare this information

  • Measurement endpoints supplied on a drawing
  • Units and fitted condition recorded
  • Damaged corners distinguished from measurement points

Review the two-door beverage cooler series

Matching model records

Discuss your site and product arrangement

Send your equipment brief