Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

Do the sections/doors have individual temperature controls for commercial kitchen equipment?

The JY-FS-2D and GN-900RT records do not specify individual temperature controls for each section or door. Both list two doors. Door count describes access to the cabinet and does not establish whether sections have separate controls. If your products need different holding temperatures, ask which compartments can maintain different temperature settings at the same time in the offered configuration.

JY-FS-2D is an 806 L beverage cooler with two glass doors. Its recorded dimensions are 1100 x 600 x 2010 mm, width x depth x height, and its listed temperature range is 0 to 10 degrees C. The record does not identify separate temperature zones or a controller for each door. A cabinet range does not establish that you can set one side to one temperature and the other side to another.

GN-900RT is a 140 L countertop cake display measuring 900 x 530 x 730 mm, width x depth x height. It lists two rear sliding doors, two shelves, fan cooling and digital temperature control with a listed range of 2 to 8 degrees C. Those entries do not state that the shelves or areas behind the doors have independent controls. Request the controller instructions for the offered version and ask which space each setting controls.

Ask for an interior drawing marked with the compartments, partitions, temperature sensors and controllers. Ask the supplier to identify each adjustable temperature setting and the compartment it controls. If the offer describes separate zones, request their individual ranges and an explanation of whether changing one setting affects another zone. This gives you a configuration to compare with your intended use without inferring the control arrangement from door count or a cabinet photograph.

List the products you plan to place in each compartment and their required holding conditions. Include the quantities and expected door-opening pattern during service. Where you need different temperatures at the same time, ask for available temperature measurements from the proposed configuration operating at those settings. Ask where each reading was taken, how the cabinet was loaded and what the surrounding conditions were. A controller display alone does not show the temperature at every product position.

Send the model codes, quantities, destination and proposed compartment layout through the inquiry form linked below. Request a reply for each order line stating whether the cabinet has one shared setting or independently adjustable zones, with the matching drawing and operating instructions. Keep the agreed configuration with the order so staff can identify which control applies to each storage area when the equipment arrives.

Prepare this information

  • Model code, configuration, quantity and destination for each order line
  • Products, quantities and required holding conditions by compartment
  • Interior drawing identifying compartments and any partitions
  • Controllers, sensors and adjustable setpoints mapped to compartments
  • Individual zone ranges and interaction between settings, if separate zones are offered
  • Operating instructions matched to the offered model and controller
  • Available measurements taken with zones at different settings, including measurement locations, cabinet load and surrounding conditions
  • Door-opening pattern during service and agreed configuration documents

Compare the upright beverage cooler model records

Matching model records

Discuss your site and product arrangement

Send your equipment brief