JINYU · Buyer question
How can I check retrieval from a deep internal tote pocket?
Choose the actual item the pocket is intended to hold, or a dimensionally matched dummy. Identify the tote sample and mark the pocket being tested on an inside view. Place the item in its normal resting position, then photograph how much remains visible above the opening. Record the position of any tab, loop or other part intended for grasping. A depth figure alone does not show whether the user can reach a useful grip.
With the bag resting in the intended position, observe a person locating the item, grasping it and withdrawing it. Describe any need to turn the pocket outward, lift the lining or tip the bag. Show those steps as separate images rather than photographing only the item after removal. Repeat after placing the normal contents in the main compartment. If the trial uses a table rather than a carried bag, label that setup explicitly so the result is reproducible.
Compare the retrieval sequence with the proposed pocket drawing. Mark the opening height and internal bottom associated with the tested sample, then identify the movement that needs discussion. Send that record through the canvas tote inquiry. If a shallower pocket or another opening position is proposed, keep it as a drawing request until a revised sample is available. Retest with the same object and setup when comparing the revision. Easier grasping in one setup does not establish retention when the bag is moved.
Prepare this information
- Resting item position shown
- Grasp and withdrawal sequence recorded
- Revised sample compared with the same object