Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

How do I check finger access around a cake board inside a display cabinet?

A cake board can fit on a shelf while leaving little room for the server to grasp it. Place a representative board in the proposed display position and mark the edges staff normally hold. Include its actual overhang, wrapping and any projecting decoration. Record the board dimensions separately from the cake diameter so the review uses the part being lifted.

Observe the grip from the service side of the proposed cabinet or a dimensioned mock-up. Show the shelf edge, door frame and neighbouring presentations in the same view. Record whether the server can reach the intended grip with the board resting in place, then maintain it during removal. Repeat at an end position beside the frame; an unobstructed middle position does not represent every space on the shelf.

Photograph the starting position and the point where access becomes restricted. Attach those views to the GN-1200R2 inquiry with the exact offered service-opening drawing requested for comparison. Keep any proposed rearrangement beside the original trial. The useful result is a board position and grip that were demonstrated under recorded conditions, rather than a shelf-width calculation alone.

Prepare this information

  • Board edges used for gripping
  • Frame and neighbouring products in view
  • Starting and restricted positions photographed

Review the straight glass cake display series

Matching model records

Discuss your site and product arrangement

Send your equipment brief