JINYU · Buyer question
How do I compare zipper operation before and after a tote sample revision?
Make a comparison sheet with the original and revised sample identifiers, drawing references and the particular change requested. Keep the earlier photographs beside the matching views of the revision. Note visible component differences, including a changed pull, tape position or lining seam, where those details are supplied or can be observed. A new sample identifier alone does not explain which construction detail was changed.
Set both samples in the same orientation and use the same sequence: show the closed resting position, grasp the pull, open the zipper and show the open resting position. Then record the closing movement. Check the specific location identified in the original issue report, using the same fabric and handle arrangement. If contents were part of the original trial, identify them and repeat that setup separately from the empty-bag comparison. Record any setup difference that prevents a direct comparison rather than silently changing the conditions.
Write the observed result next to each requested change. For example, distinguish a catch no longer seen at the marked seam from a new difficulty reaching the pull at an endpoint. Send the comparison through the canvas tote inquiry with the revised drawing reference and any remaining question linked to its photograph. Keep appearance observations separate from movement observations so a matching tape colour does not stand in for an operation check. A short sample comparison documents these movements; a durability claim would require separate evidence describing the test performed.
Prepare this information
- Requested change linked to both sample identifiers
- Same movement and setup used for comparison
- Appearance and operation results recorded separately