JINYU · Buyer question
What should I check at both ends of a tote zipper on a sample?
Place the sample in the orientation used on its closure drawing and identify each zipper end as A or B. Photograph the slider at its normal open position and at its normal closed position. Include the surrounding seams, tabs and bag panels in these views. Record where the slider comes to rest relative to those features. Use the component references supplied with the sample when available; a photograph alone may not identify which endpoint arrangement was proposed.
Observe the last part of the movement toward each end without pulling beyond the normal resting position. Note any fabric caught near the end, a tab that folds into the path or a pull that becomes difficult to grasp. Keep those observations separate for A and B. With the zipper open, photograph the access left between the attached panels. If measuring it, name the endpoints and state whether the bag is lying flat or held open. Do not substitute the tape length for that finished opening.
Attach the two endpoint views and the assembled opening view to the canvas tote inquiry. Mark any difference from the drawing beside the relevant endpoint label. Ask for an updated assembled view if the proposed change moves a seam, tab or slider resting position. When comparing a later sample, use the same bag orientation and measuring condition. This gives the reviewer an identifiable change at each end rather than an unexplained difference in two overall bag photographs.
Prepare this information
- Both zipper ends labelled on the sample
- Open and closed resting positions shown
- Finished opening measured from named points