JINYU · Buyer question
How do I define reference points on a bag sample measurement sheet?
Give the physical sample an identifier and put that identifier on the measurement sheet and photographs. Name the front, back and base views. For each dimension, draw a line with visible endpoints on the matching photograph. State whether each endpoint is an outside fabric edge, a seam line or another identifiable feature. A width measured across the outside edges cannot be compared directly with a width taken between stitch lines.
Record the sample condition beside the line: laid flat, base opened or another clearly described arrangement. For a flat measurement, describe how folds were positioned and whether the contents were removed. Keep the ruler in the same plane as the measured feature. Photograph its starting mark and ending mark together where possible; a cropped view showing only the final reading loses the reference at the other end. Write the unit in the column heading rather than relying on the reader to infer it from a photograph.
Link each result to the corresponding drawing dimension, if one exists. Leave a separate note when the drawing uses different endpoints instead of treating the two numbers as equivalent. Send the sheet, marked images and drawing revision with the canvas tote inquiry. Ask the reviewer to identify the intended endpoints on the returned drawing. Keep both methods visible until that difference is resolved so a later sample can be checked using the agreed reference points.
Prepare this information
- Sample identifier on sheet and images
- Endpoints marked on a named view
- Condition and units recorded