JINYU · Buyer question
How should I record handle drop and handle length on a tote sample?
Use separate rows for handle drop and handle length. For the drop, mark the reference line at the bag opening and the point on the inside of the handle being measured. Show the handle position in a photograph. State whether the handle is resting in place or held in a described position, and keep the bag empty for that record. The phrase handle size alone does not tell another reviewer which of these features was measured.
For a length along the handle, mark the start and finish at the attachment areas and show the path followed by the measuring tape. State whether the measurement follows the visible handle surface or refers to a dimension on the construction drawing. An attached sample may conceal part of the handle inside a seam, so a visible surface measurement cannot establish the original cut length. Record that distinction on the sheet rather than estimating the hidden section.
Measure the front and back handles separately using the same method and label their photographs. If they appear different, include both results and the attachment locations; a single overall photograph may hide which handle is being discussed. Send the marked sheet with the canvas tote project inquiry and ask for corresponding dimensions on the offered drawing. Retain the sample identifier and drawing revision with the reply. These records describe geometry in the stated setup and provide no carrying-load rating or evidence of comfort with a particular packed load.
Prepare this information
- Drop and length recorded in separate rows
- Handle position and tape path photographed
- Front and back handles identified