Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

How do I distinguish zipper length from the usable opening on a tote drawing?

Draw the proposed zipper on a top view of the bag. Label the tape ends and the points where the slider travel starts and stops. Put each dimension beside its named endpoints and state the units. A single length marked zipper can otherwise refer to the tape, the fastening section or the opening in the finished bag.

On a separate assembled view, show where the zipper ends meet seams, tabs or folded panels. Mark the portion of the bag mouth that can actually open when the slider reaches its open position. Ask the returned drawing to identify these same points; do not infer usable access by subtracting an assumed amount from a component length.

If a sample is supplied, photograph it fully open with a scale beside the marked opening. Record the sample reference and compare the observed opening with the assembled drawing. Send the paired views through the inquiry when asking for a change. Keep component length and finished opening as separate entries in the revised record.

Prepare this information

  • Tape and slider-travel endpoints labelled
  • Finished opening shown on an assembled view
  • Sample measurement uses the same reference points

View the canvas tote project

Matching bag projects

Discuss your bag specification

Send your bag brief