JINYU · Buyer question
What coordinates should I give for paired fastening parts on a tote?
Draw both surfaces carrying the proposed fastening parts. Label the parts A and B, and locate each centre from a named top edge and side reference. State whether the measurements refer to a flat panel before assembly or the finished bag. Use the same units throughout; a single centre mark on the front view leaves the second half unlocated.
Add a sectional sketch or opened view showing how the two parts meet. Include any proposed tab, facing or folded edge that carries a part. If the surfaces overlap, show which sits above the other. Ask the supplier to identify the mating parts and return their proposed attachment details on the drawing before using those details in the bag brief.
For a sample comparison, photograph each part with the bag open and then show them fastened. Compare their positions against the same reference edges. Record unequal placement separately from any difficulty bringing them together. Send the marked views with the inquiry so a requested position change identifies the affected half and drawing revision.
Prepare this information
- Both part centres dimensioned
- Flat-panel or finished-bag measuring condition stated
- Mating relationship shown in an assembled sketch