JINYU · Buyer question
How can I check display fridge fit before the shop counter is built?
Draw the selected cabinet on a plan and a side elevation before the shop counter is built. Label the supporting surface, cabinet footprint, rear serving side and adjacent equipment. Give the designer the exact model code and drawing revision so the furniture layout follows the cabinet being considered.
GN-900RT measures 900 × 530 × 730 mm; GN-1200RT measures 1200 × 530 × 730 mm. Both are countertop displays with rear sliding doors. The wider model adds 300 mm of frontage while retaining the same recorded depth and height. On an illustrative 900 mm-high supporting surface, either cabinet reaches 1630 mm above the finished floor. That calculation locates the top of the cabinet; installation spacing, support requirements and usable shelf dimensions need their own model-specific information.
Mark the lowest overhead shelf or fitting on the elevation and the staff loading position on the plan. Use the intended tray or cake board in a full-size layout trial to review the route from display to packing surface. Send the measured counter width, depth and support height with the inquiry, together with the proposed support construction and nearby obstructions. Update the furniture drawing when the model or supporting surface changes.
Prepare this information
- Exact model and counter drawing revision
- Footprint and floor-to-cabinet-top height
- Support details, overhead objects and rear serving route
Calculate countertop display floor-to-top height