JINYU · Buyer question
How do I measure an irregular counter opening for a replacement display fridge?
Draw a plan and elevation of the opening, marking the front, rear, left and right sides. Locate it from the survey wall reference and fixed height datum. Measure the width at named positions and heights, including near projecting trims or brackets. Record each reading at its location on the drawing, with the survey date and revision. Keep the smallest observed gap visible in the schedule alongside the other readings rather than replacing them with one average width.
Measure depth from a defined front reference line to the rear obstruction at each relevant height. Include the underside of the worktop, plinth returns, internal shelves and wall projections. Take diagonal measurements where they help describe an opening that appears out of square, and label both endpoints. Link photographs to the same measurement locations. Pair a close view of the measuring scale with a wider view that shows its position in the opening.
Keep direct measurements separate from dimensions copied from earlier drawings. Put the source drawing reference and revision beside each copied value. Mark areas concealed by the existing cabinet as unmeasured. List assumptions separately, with the source document or person and date for each. A proposed removal of a trim or bracket does not establish the clear opening available after removal.
Compare the selected survey revision with the drawing for the exact offered model and configuration. Identify both drawing revisions on the comparison. Keep measured opening dimensions separate from cabinet body dimensions and the access or installation requirements stated in the offered documents. Overlay those requirements at the named survey locations and mark unresolved gaps beside the affected points. Send the dimensioned sketches and image index through the inquiry entry with the model references below.
If the proposed cabinet position changes, retain the original readings with their locations and dates. Add dated measurements at the revised position against the same wall reference and height datum. When a new reading replaces an assumption, link it to the affected point in the revised survey and retain the assumption in the earlier record. Keep earlier comparison drawings with their original survey and cabinet drawing references.
Prepare this information
- Dated plan and elevation with wall reference, height datum and named measurement points
- Multiple width, depth and diagonal readings with the smallest observed gaps retained
- Direct readings, copied drawing revisions, unmeasured areas and sourced assumptions
- Selected survey and offered configuration drawings with separate installation requirements
- Revised locations and dated readings linked to retained earlier records
Compare the open-front display series