JINYU · Buyer question
How do I document a remaining cooler-position difference and the equipment drawing response?
Use the original S1 or S2 reference from the installed-condition record to connect the inquiry with the equipment drawing reply. Include B2, its installed model code, the drawing number and revision, the measurement date and photograph reference. Retain the fixed height datum and selected front or rear alignment in the reply drawing. The linked installed-row question explains the measurements. This record identifies the target and proposed action in the reply, then tracks the later measured result.
Continuing the illustrative S1 example, revision R2 shows a proposed opening of 1780 mm, while the installed opening measures 1778 mm between the wall reference and the inside face of the end panel. The difference is 1778 - 1780 = -2 mm. Suppose the reply retains the 1780 mm target in revision R3 and proposes moving the panel face 1780 - 1778 = +2 mm away from the wall reference. Record the reply date, R3 reference and proposed movement in the S1 entry. Keep the observed 1778 mm reading in its dated entry. After adjustment, an illustrative reading of 1779 mm gives 1779 - 1780 = -1 mm against the same target. Record that later reading and its photograph separately from the proposed movement.
For the separate S2 example, the installed B2 top measures +2038 mm against a proposed +2040 mm, with the sign underside measured at +2190 mm. Suppose the reply retains the +2040 mm top target and proposes raising the cabinet top by 2040 - 2038 = +2 mm. Record the action in the S2 entry using the same fixed height datum. If a later survey reads a cabinet top of +2039 mm and an unchanged sign underside of +2190 mm, the top difference is 2039 - 2040 = -1 mm and the measured gap is 2190 - 2039 = 151 mm. Date both readings and attach the corresponding photographs. Keep the earlier measured 152 mm gap and proposed 150 mm gap in their original entries. The proposed body-bottom level and measured floor readings remain separate.
Link each reply to the affected plan, elevation or equipment detail. Record whether the selected alignment stays the same. If the reply moves the cabinet footprint, show its previous and proposed positions and identify the floor readings for the revised footprint. Reference the selected equipment drawing for any response about door movement, ventilation, connections or service access. If the reply addresses a different cabinet or endpoint, ask how it addresses the B2 observation recorded under S1 or S2. Send the updated record through the inquiry with the model code and original observation reference. These example movements and gaps establish no installation tolerance or acceptance.
Prepare this information
- Original B2 and S1 or S2 references connect the observation, reply and drawing revision
- Reply retains the height datum and records the selected alignment at any revised footprint
- Proposed movement and target remain separate from each dated measurement and photograph
Prepare the installed-row measurement record