Skip to content
JINYUCOMMERCIAL KITCHEN EQUIPMENT
Menu

JINYU · Buyer question

How do I record floor levels and cabinet alignment for a beverage cooler row?

Label the cabinet footprints C1, C2 and C3 on the plan. Mark a fixed height datum and record the finished floor at the front-left, front-right, rear-left and rear-right corners of each footprint relative to it. Write the corner names beside the readings, and record the survey date and instrument used. Photograph steps, joints, or damaged areas using the same cabinet labels. One reading at the end of the row can miss a rise beneath another cabinet. Carry these position labels into later drawing revisions. If a selected option uses B2 for the position previously labelled C2, record that correspondence beside the drawing revision so the floor readings remain traceable.

For an illustrative C2 survey, use a fixed reference level of 0 mm. The floor readings are front-left +0 mm, front-right +6 mm, rear-left +2 mm and rear-right +8 mm. Positive values mean the floor is above that reference. The right side is 6 mm higher than the left at both ends, and the rear is 2 mm higher than the front on both sides. These example readings describe the site. Map the offered support locations onto this survey, and record the proposed support settings separately using the levelling details for that version.

Draw the selected front or rear alignment line beside the footprints. JY-LC-318 is 550 mm deep; JY-FS-1D and JY-FS-2D are 600 mm deep. Aligning the fronts places the rear edges of the deeper cabinets 50 mm farther toward the wall. Aligning the backs places the fronts of the deeper cabinets 50 mm farther toward the aisle. If a footprint moves during that choice, mark its revised corners and measure the floor at those positions. The original readings remain observations of the original footprint.

In the elevation, show each body-bottom level for the proposed support arrangement and add its recorded body height. For an illustrative level arrangement, C1 is JY-LC-318 with its body bottom at +10 mm, giving a top level of 10 + 1900 = 1910 mm. C2 is JY-FS-1D with its body bottom at +20 mm, giving a top level of 20 + 2010 = 2030 mm. Their top levels differ by 2030 - 1910 = 120 mm. These proposed body-bottom levels are separate example values, not settings derived from the four corner readings. Record all body-bottom and top levels against the same fixed height datum used for the floor survey. If a later drawing raises the proposed C2 body bottom to +30 mm, its proposed top becomes 30 + 2010 = 2040 mm. Keep that proposal beside the earlier +20 mm value and the dated floor readings. Send the survey, alignment plan, and elevation through the inquiry with the model codes and cabinet labels. The linked overhead question uses these same top levels to calculate gaps beneath a sign.

Prepare this information

  • Corner readings identify the footprint, fixed datum, sign convention and position label across revisions
  • Selected alignment and any revised floor measurement positions appear on the plan
  • Proposed body-bottom and top levels remain separate from dated floor and installed-top measurements

Measure signs and soffits above the cooler row

Matching model records

Discuss your site and product arrangement

Send your equipment brief